Installation Steps

---

• Holds 1 single or double sided sign
• 8‘ vertical posts
• Installs in the ground or over T-posts

(T-post/fence post 4‘ to 5‘ not sold by 1-800-The-Sign)

Open the Package

Remove the frame from the box, then unscrew the single packaging screw from the frame post.

STEP 1 - Assemble Frame and Sign

Slide the horizontal support tracks on to the sign face so they are even with the edges of the sign. Check that the tracks line up with the holes in the vertical posts before screwing the tracks. Screw the small screws into the pre drilled holes. Place 2 starter arrows in the corrugation openings on the edge of the sign, approximately 16” apart. Place the vertical posts on the ground, with the slot for the sign facing up . Twist out the tab in the center of the slot. Lift the sign, tracks and arrows, and slide one corner into the slot on the post until it hits the stopper. Work the sign into the slot from the inserted corner to the opposite corner, Screw the sign and tracks into place with the large screws. Lift the sign and the attached post to insert the sign into the second post starting at one corner. Install the large screws.

STEP 2 - Screw Together

Screw the four large head screws into the vertical posts. Screw the eight small head screws into the horizontal supports. With standard vinyl flat caps place them at the top of the vertical posts, with the gothic post cap option use the screws provided. Do not skip any screw holes.

STEP 3 - Dig the Holes

Using the sign as a spacing guide dig the holes 18" to 24" deep depending on the soil. Maneuver the assembled sign into the holes. Insure the sign is level and re-fill the holes packing them tightly.

Warning: Wear safety equipment including leather gloves and eye protection. Due care should be taken to avoid blocking visibility, pathways etc. Consult the proper authorities prior to installing the sign to insure there are no underground hazards, obstacles, utilities, pipes, etc.. There may be local regulations regarding the use of these signs.

------- or --------

STEP 3 - Post Pounder

Using the sign as a spacing guide drive the t-post 12 inch to 18 inch deep, depending on the soil, on a level surface. Simply lift the assembled sign frame and slide it over t-posts. Tip: Pounding the t-posts on a slightly angled away from each other will hold the sign snug.

(4’ to 6’ T-post/fence post not included)

Warning: Wear safety equipment including leather gloves and eye protection. Due care should be taken to avoid blocking visibility, pathways etc. Consult the proper authorities prior to installing the sign to insure there are no underground hazards, obstacles, utilities, pipes, etc.. There may be local regulations regarding the use of these signs.

Download this guide